CNC Machining and CNC Machine Tools

The machine fall machine note, absolutely can not be ignored!

The fall machine should pay attention to the following matters.

A preparatory work:

The foundation according to the foundation plan well to meet the requirements of the foundation, to support the machine level and firmness. Like F3, F5, PS65, PS95, V33i, reinforced concrete thickness is about 50cm.

Professional handling lifting company – hoisting contact qualified, Makino each machine provides special lifting sling, according to figure lifting. If the customer does not buy sling, wire rope is to get enough strength, enough bearing or forklift.

The temperature change has great influence on the machining accuracy, proposed to achieve precision management at room temperature, the most ideal environment. The average temperature 10 to 40 DEG C, the optimal temperature control table, maintain the relative humidity: 75% (to avoid condensation).

The power – power standard in place, in accordance with the standard to determine the electrical cable size. As Makino common machine tools, F3, F5, PS65, PS95, E33, E56, V33i, V56i, EDGE2, 25mm – cable.

The gas source to provide clean and dry air source, like the above machine, the pressure of 0.5Mpa or above, the flow of more than 600L/Min.

Two, step off the machine:

1) check out of the box, each box has no obvious damage, according to the shipping list inventory items.

2) the main machine handling, if the use of forklift, please adjust the forklift shovel into position, make the machine stable center of gravity, tilt and cause the machine tool to avoid personal injury; the shovel, and any part of forklift machine to keep at least 15cm distance, prevent scratch sheet metal.

3) the machine body in accordance with the foundation size chart is put in place, put aside machine with other peripheral equipment space; all anchor at approximately the same height of the support, not a vacant anchor, to prevent deformation of machine.

4) peripheral devices placed in place, including transformer, oil cooler, air dryer, specific location according to the available prior to placing map, if not clear, feel free to contact the Makino consulting company.

Standby bed in place, you can install the debugging.

Source: Makino China



For more information about this article and how we can help with your project, please contact us today.

CNC Machining Service & CNC Machining parts